Ohaus MB23 MOISTURE ANALYZER Manual it - Manual (Page 5)

MB23 / MB25 EN-3
3. OPERATION
Display
 Stable indicator
% Percent solids
%  Percent moisture
g grams
100° Temperature setting or current chamber temperature (Celsius)
10:00 Time setting (minutes : seconds)
Controls
Button: Name: Quick Functions: Button: Name: Quick Functions:
Start / Stop
On (short press) / Off (long press)
Start/Stop (short press)
Back (short press)
Set 
Increase value
(short or long press)
Tare
Tare (short press)
Enter / Accept value (short press)
Set 
Decrease value
(short or long press)
Temp Temperature Setting (short press) Print / Cal
Print (short press)
Calibrate (long press)
Time Time Setting (short press) %g Result Unit (short press)
There are also several modes of operation which affect how each button operates. Please refer to the following section.
Operating Modes
Standby Mode
When the Analyzer is connected to AC power and the display is off, the unit is in Standby mode.
Start
(Short press) Turns on the display and enters Weigh mode.
Print (Long press) Displays the RS232 settings (see Section 6, RS232 Data Connection.). Thereafter,
(Short press) Re-enters Standby mode (off).
Weigh Mode
The display shows the weight of items placed on the pan support.
Tare
(Short press) Sets the displayed weight value to zero
Start (Long press) Enters Standby mode (Off)
The following operations can be initiated:
Temp
(Short press) Enters Edit mode for the temperature setting, the value will blink
Time (Short press) Enters Edit mode for the time setting, the value will blink
Start (Short press) Activates Run mode, initiates test with a sample greater than 0.5 g
Cal (Long press) Initiates weight or temperature Calibration (see Section 5, Maintenance)
Temperature / Time Edit Mode (Preparing a Test)
Temperature editing: (50° to 160°C in 5° steps)
Temp
(Short press) Enters Edit mode for the temperature setting, the value will blink.