Remote control preparation, Battery installation, Service life of battery – Naxa NT-50 User Manual
Page 9

8
REMOTE CONTROL PREPARATION
BATTERY INSTALLATION
Install the battery as the follow picture. Be sure negative and positive terminals are
positioned as indicated in the battery compartment. (Fig1 )
SERVICE LIFE OF BATTERY
-The battery normally last for about one year although this depends on how often, and
for how often the remote control is used.
-If the remote control fails to work even when it is operated near the player, replace the
battery.
- Use one size CR2025 battery.
Note:
l
Do not use rechargeable (Ni-Cd) battery.
l
Do not attempt to recharge, short-circuit, disassemble, heat or throw
the batteries into the fire.
l
Do not drop, step on or otherwise impact the remote control. This may
damage the parts or lead to malfunction.
l
If the remote control is not going to be used for a long time, remove
the battery.
REMOTE CONTROL OPERATION
1. Remove the protective plastic tab before
operating the remote control.
2. Point the remote control from no more than
about 6 m from the remote control sensor and
within about 60
º of the front of the player (Fig 2).
NOTE:
-The operating distance may vary according to
the brightness of the room.
-Do not point bright lights at remote control
sensor.
-Do not place objects between the remote control and the remote control sensor.
-Do not use this remote control while simultaneously operating the remote control of any other
equipment.