Naxa NT-50 - Manual (Page 10)

9
BASIC OPERATIONS
MAKE SURE ALL THE EQUIPMENTS AND AC ADAPTOR ARE CONNECTED PROPERLY
AND THE UNIT IS SET IN CORRECT MODE BEFORE KINDS OF OPERATIONS.
TURN ON THE UNIT
Press STANDBY button of the unit to turn on the unit (The power indicator will display green
color). Press it again to standby the unit (The power indicator will display red color) .
AUTO SEARCHING
Before normal watching you must search effective channels first.
-Press MENU button on remote control, the screen will display:
-Select AUTO SEARCH item, press right button to enter this item.
-Set the SOURCE TYPE what you want. Select START SEARCH item then press right to start
to search channels automatically. Wait for several minutes until searching finished, then the
first searched channel will play.
NOTE: You must do auto search again after different system selection according to your area.
SELECT WANTED PROGRAM
1. Press CH + button to enter next channel.
2. Press CH - button to enter previous channel.
3. Press numeric buttons on the remote control directly to select program what you want.
Example: Track 9, press "9" three seconds later, it will automatically switch to track 9,
or press ENTER button to confirm directly.
Track 12, press "1 " and "2", three seconds later, it will automatically switch to track12,
or press ENTER button to confirm directly.
NOTE: If one frequency dot has more than one channel, for example, you want select
, press 1 and 4, then press right navigation button and input 2. Press ENTER
button to confirm. Once the input is done, it will start broadcasting the selected channel
immediately.
VOLUME CONTROL
1. Press the VOL+ or VOL- to adjust the level of currently volume.
2. The level of VOLUME can be adjust from 0-40.
MUTE CONTROL
Press the MUTE button to mute the sound, press it again to switch ON the sound.
NOTE: When the unit is in Mute mode, pressing VOL+ button will switch ON the sound and
turn it up, pressing VOL- button will switch ON the sound and turn it down.