Herman Miller SAYL Chairs - Disassembly For Recycling - Manual

Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, SAYL are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, and Tu are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 1
Part no. 1b9rth rev A.
Y
SAYL
®
Disassembly for Recycling
Tools Required:
Power driver Safety Glasses T-40 Torx Driver Flat Screw Driver Hammer Rubber Mallet Nose Plier
Steps:
2. Remove all casters. 1. Hold base and pull hard
to remove caster from base.
Where possible, plastic components are marked with ASTM recycling codes. Use
these codes to identify material type for recycling. Non marked components should
be treated as mixed plastic. Ferrous metals can be identified using a small magnet
for recycling. Non-ferrous metals should be separated and recycled separately.
Materials Identification and Segregation: