Dunlop Manufacturing JC95 - Manual (Page 2)

POWER
The Jerry Cantrell Signature Cry Baby ®
Wah Wah is powered by one 9-volt battery
(accessed via the bottom of the pedal),
an AC adapter such as the Dunlop ECB003/
ECB003E, or a DC Brick ™ power supply.
SETUP INSTRUCTIONS
• Run a shielded instrument cable from your
guitar to the JC95’s INSTRUMENT jack.
• Run another shielded instrument cable
from the JC95’s AMPLIFIER jack to
your amplifier input.
• Turn on the amplifier and begin playing.
• To turn the pedal on/off, push the toe of
the pedal down until you feel a “click.”
• Rotate the FINE TUNE knob clockwise for a
brighter toe-down response or counterclock-
wise for a darker toe-down response.
SPECIFICATIONS
Impedance
Input 1 MΩ
Output 10 kΩ
Filter Center Frequency
Heel Down 320 Hz to 390 Hz
Toe Down
Fine Tune Max 1700 Hz to 2070 Hz
Fine Tune Min 1050 kHz to 1270 Hz
Maximum Level
Input -11.5 dBV
Output +6 dBV
Maximum Gain at Center Frequency
Heel Down +18 dB
Toe Down +20 dB
Noise Floor *
Heel Down >97 dB
Toe Down >89 dB
Bypass Hardwire
Current Draw
1 mA
Power Supply 9 volts DC
*V
REF
=1V
RMS , A-weighted
JC95 JERRY CANTRELL CRY BABY
®
WAH WAH