Garmin Rino 120 - Manual (Page 101)

Rino ® 120 Owner’s Manual 95
A
PPENDIX
> T
RANSFERRING
M
AP
S
OURCE
D
ATA
To setup for data transfer:
1. Remove weather cap from the Power/Data Port
on the back of the unit by lifting up on the rubber
weather cap.
2. Connect the serial port connector on the cable to
an available serial port on your computer.
3. Connect the remaining cable connector to the
back of the Rino 120 by orienting the slot on the
connector with the indexing bar on the back of the
unit and push the connector until it is fully seated
in the unit.
4. Turn on the Rino 120 and follow instructions for
map data transfer provided in the MapSource
User’s Manual. See also the “Interface Setup
Page” section for unit interface settings.