Acura 2008 RDX Navigation - Manual (Page 132)

132 Navigation System
When I drive at night, the screen is bright and will not switch
to the night display mode. Why? Verify the following: The display mode in Set up is set to Auto, the dash
brightness is not set to maximum, and Map Color in Set up is set to Black
for Night. See Switching Display Mode on page
103 .
The daytime map screen is dark like the night display mode,
and it is hard to see. Why? Verify the following: The display mode in Set up is set to Auto, and Map
Color in Set up is set to White for Day. See Switching Display Mode on
page
103 .
During the day, I turned on the lights because it started to
rain, but the screen went dark. How can I make it still display
day mode? Adjust the dash brightness (+) knob to full brightness. Remember to set it
back to a medium setting, or at night, the screen will be bright. See
Switching Display Mode on page
103 .
How can I input my destination using map coordinates? The navigation system was not designed for this. However, you can view
the coordinates of an address by pushing in on the Interface Dial, selecting
Show Icon on Map, and moving the Interface Dial left to select
Current Location. See Displaying Current Location on page
20 .
How do I change or remove my PIN? Go to “Personal Information” in the Set up screen (second), and select PIN
Number. Enter your existing PIN, and then you have the choice to change
or remove the PIN. See page
88 .
I forget the PIN. How do I reset it? PINs are optional. See information regarding PINs on page 88 . Your dealer
can reset the PIN for you.
CALL is not available on the Calculate route to screen. Why? Your phone is not “paired” to the HFL, or if your phone is “paired,” it is in
use; press HFL BACK button.
Problem Solution
Frequently Asked Questions
2008 RDX
Main Menu