beautypg.com

System limitations, 2008 rdx – Acura 2008 RDX Navigation User Manual

Page 109

background image

Navigation System

109

System Limitations

Although your navigation system is one
of the most highly sophisticated pieces
of equipment you will find in a modern
automobile, you may find during its use,
that it has certain limitations.

The system uses signals from the Global
Positioning System (GPS) to aid in
determining its current location. The
GPS is operated by the U.S.
Department of Defense. For security
reasons, there are certain inaccuracies
built into the GPS that the navigation
system must constantly compensate for.
This can cause occasional positioning
errors of up to several hundred feet.

For example, in urban areas where
streets are close together, this could
cause the system to show that you are
traveling on a street that parallels the
street you are actually on. The system
will, under most circumstances, correct
itself while you drive.

Also, depending on your current view of
the sky and the position of the satellites,
the elevation may be shown incorrectly.
You may also notice some delay of the
vehicle position icon at intersections;
this is normal.

GPS Reception Issues

The signals received from the GPS
satellites are extremely weak (less than
a millionth of the strength of a local FM
station), and require an unobstructed
view of sky. The signal can easily be
interrupted or interfered with by the
following:

• After-market metallic window tint

above or to the sides of the GPS
antenna (located under the dash)

• Cell phones, PDAs, or other

electronic devices docked in a cradle
or laying loose on the dash

• Radar detectors mounted on the dash

• Remote starters, or “hidden” vehicle

location systems mounted near the
navigation unit

• Other after-market audio electronic

devices mounted near the navigation
unit

• Trees, tall buildings, freeway

overpasses, tunnels or overhead
electrical power wires

Although the system will direct you to
your desired destination, it may not
always generate what you consider to be
the most direct route. Try changing the
method of routing. See Changing the
Routing Method
on page

50

. You may

also have Unverified Area Routing set
to “OFF.” See Unverified Area Routing
on page

91

.

2008 RDX

Main Menu

This manual is related to the following products: