Acura Embedded AcuPanel 19 - Manual (Page 65)

Chapter 3: System Setup
3. Slide the Panel PC through the hole until it is properly fitted against the
panel.
4. Position the mounting clamps along the rear edges of the Panel PC. The
first and second clamps must be positioned and secured diagonally prior
to mounting the rest of the clamps. Tighten the clamp's screw until it
touches the panel.
AcuPanel 19
Clamp
Panel
CAUTION!
Do not overtighten the screws to prevent damaging the
Panel PC.
60
366.00
436.00
Panel Mounting
1. Select a place on the panel where you will mount the Panel PC.
2. Cut out a shape on the panel that corresponds to the Panel PC's rear
dimensions.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall, etc.)
where you will mount the Panel PC must not exceed 6mm. If the distance
between the front bezel and panel mount hole is too wide, it will not fit the panel
mount kit.
6mm