beautypg.com

Powering on for the first time – Acura Embedded AcuTab-M User Manual

Page 6

background image

You can click

or

to reduce or increase the LCD brightness. Also, you can slide the

scale bar

to set the brightness.

Volume Control

For Volume adjustment, press the Volume

icon.










When you press it, the Volume control panel is appeared as follows:





You can click

or

to reduce or increase the audio volume

incrementally.

Also, you can slide the scale bar

to set the audio volume. You can

tick the Mute

to mute the audio.

Launch Webcam Utility

For Webcam Launch, press the Webcam

icon to launch the Webcam utility. Or can

access the Webcam

icon located on desktop.


Monitor Switch

For Monitor switch, press the Monitor Switch

to pop-up the selection bar for choosing the

display mode within following four options.













You can click Duplicate

to display the same contents both on the default

screen and external display device. The resolution on these two display modes are
same, it is not available to adjust the resolution on the external display mode.

You can click Extend

to display the different contents on the default screen

and external display device. You only can adjust the resolution on the external display
device.

You can click Projector only

to display on external projector only.

Powering on for the first time

The Power/Resume button is found on the left side of the AcuTab-M. Press the
Power/Resume button to start your system and check that if the Power LED turns on.

After a few seconds, the system’s display will turn on and your system will begin to execute
the Power On Self Test or POST to check if all system components are running properly. Any
error found during the test will be displayed on the screen.

After the test, the screen will also display a message "press to enter SETUP". You don’t
need to run this program at the moment as your dealer already made the necessary settings for
your computer optimal operation.

After the test has completed, your computer will start to search and boot up the
operating system from your hard drive.

Before setting up the system, please make sure the following items are available.

10

11