Activeforever Health Craft Smart Rail System Bed Rail User Manual
Smart-rail, Installation instructions, Caution

2
5
INSTALLATION
INSTRUCTIONS
Model SR-S
Smart-Rail
3
MIN.
MAX.
2"/ 50mm.
{
6"/ 150mm.
2
3
SUGGESTIONS...
CAUTION
1
4
1
"Innovative Products for Independent Living"
The
RISK OF INJURY!
Understand these instructions prior to using product.
VERTICAL LOAD BEARING ONLY - Product intended for
moderate VERTICAL weight bearing on rail only. DO NOT
use if sideward (lateral) support is needed.
AVOID RAIL LATCH UNLOCKING - Ensure that rail is at least
2"/50mm off floor when rail is in locked position. (Soft type box
spring beds can compress downward under load allowing
support frame to move down, and rail to become unlatched).
Maximum user weight 250lbs/113kg.
Do not use on wet or slippery floors.
Do not use with electric or hospital style beds.
Supplied strap must be installed for secure operation.
Product intended for moderate assistance with sitting up and
standing only.
Insert Support Frame
Install SafeLatch
TM
Collar & Set Rail Height
Install Safety Strap
Install Cane Tips
Insert Rail
(Locate pivot tube adjacent
to hip as shown below)
(Turn frame over for
opposite side of bed)
(with rail at correct height,
turn set screw until
collar is tight on rail)
(adjust rail height to best
suit your needs within
limits shown below)
(slide up and rest
on latch hook)
Install strap over round tube (1), under and
across both square tubes (2), and back over round
tube (3) as shown below.
HealthCraft Products Inc., 2790 Fenton Rd., Ottawa, Ontario, Canada, K1T 3T7
Copyright 2004. Specifications subject to change without notice. Patent Pending.
(with finger
pin down)
Support Frame
SafeLatch
TM
Collar
(pull tight)
(loop around
bed frame)
LOCKED RAIL - grab onto
grip, or leg of rail to help
with moving in bed & sitting
up at side of bed.
HINT - grab the rail closest
to the pivot leg for most
easy lifting. Pivot rail and
place in an appropriate
location as shown.
STANDING - use rail to
help with standing up from
bed. NOTE - rail is meant
to provide support for
vertical weight bearing only.
4
5
2
3
1
TM