ACS AET65 Smart Card Reader with Fingerprint Sensor - Manual (Page 19)

Document Title Here Document Title Here
Document Title Here
AET65 Reference Manual
Version 1.00
Page 19 of 19
[email protected]
www.acs.com.hk
Appendix A. AET65
Appendix A.1. Supported Card Types
The following table shows the values that must be specified in the SET_CARD_TYPE command for a
particular card type to be used, and how the bits in the response to the GET_ACR_STAT command
correspond with the respective card types.
Card Type Card Type
00
H
Auto-select T=0 or T=1 communication protocol
0C
H
MCU-based cards with T=0 communication protocol
0D
H
MCU-based cards with T=1 communication protocol
Appendix A.2. Response Status Codes
The following table is a list of the possible status code returned by the AET65:
Status Code Status
00 OK – command successfully executed
F4 SLOTERROT_PROCEDURE_BYTE_CONFLICT
F6 SLOTERROR_BAD_LENGTH
F7 SLOTERROR_BAD_FIDI
F8 SLOTERROR_BAD_ATR_TS
F9 SLOTERROR_ICC_NOT_POWERED_UP
FA SLOTERROR_ICC_NOT_INSERTED
FB SLOTERROR_HW_ERROR
FC SLOTERROR_XFE_OVERRUN
FD SLOTERROR_XFE_PARITY_ERROR
FE SLOTERROR_ICC_MUTE
FF SLOTERROR_CMD_ABORTED