ACS AET65 Smart Card Reader with Fingerprint Sensor - Manual (Page 14)

01H : card inserted, not powered up
03H : card powered up
9.1.2. SELECT_CARD_TYPE
This command sets the required card type. The firmware in the AET65 adjusts the communication
protocol between reader and the inserted card according to the selected card type.
Command format
Header Instruction Data length Data
LEN TYPE
01 H 02 H 00 H 01 H
TYPE See Appendix B.1 for the value to be specified in this command for a
particular card to be used.
Response data format
Header Status Data length
LEN
01
9.1.3. SET_OPTION
This command selects the options for the reader.
Command format
Header Instruction Data length Data
LEN Option
01 H 07 H 00 H 01 H
Option Bit 4: Select for EMV mode
Specifies whether the reader is in EMV mode
0 : Reader not in EMV mode (default)
1 : Reader in EMV mode
Bit 0, 1, 2, 3, 5, 6 and 7: Reserved
Response data format
Header Status Data length
LEN
01 H
Document Title Here Document Title Here
Document Title Here
AET65 Reference Manual
Version 1.00
Page 14 of 19
[email protected]
www.acs.com.hk