ACR&Artex GlobalFix iPro - Manual (Page 34)

Y1-03-0233 Rev. J 33
APPENDIX D - USER INTERFACE: DIGITAL DISPLAY
DURING SELF-TEST
The following chart describes the display and audio-visual feedback the
beacon provides during Self-Test. The messages on the digital display
typically appear as one or two words at a time, until the entire message has
been displayed.
GlobalFix™ iPRO Display, LED/ Audio Signaling and Description of Operation
Beacon Self- Test has been initiated, and the ACR Electronics’ Welcome Page appears.
Next, the product name page appears.
The first test checks the available hours of battery life (battery witness seal). If remaining
battery life is greater than 48 hours at -20° C, the test passes.
The first test checks the available hours of battery life (battery witness seal). If remaining
battery life is less than 48 hours at -20° C, the test fails.
The second test checks the beacon message for absence of errors
(EEPROM memory). If no errors are present the test passes.
The second test checks the beacon message for absence of errors (EEPROM memory). If
an error(s) is present, the test fails.
The third test checks circuit board (lock circuit)
functionality. If the board is performing properly, the board passes.
The third test checks circuit board (lock circuit) functionality. If the board is not performing
properly, the board fails.
BATT > 48HR √ beep
BATT > 48HR  beep beep
MEM
√ beep
MEM  beep beep
BOARD TEST √ beep
BOARD TEST  beep beep
G
R
G
R
G
R