ACR&Artex Survival Radio - Manual (Page 13)

Y1-03-0128G 12
8. If the test signal was not heard (full quieting), replace the
battery and retest. If the test signal is still not heard (full quieting),
have the unit inspected at your nearest authorized service center.
9.
Have someone return the call from the monitoring station
(lowest power setting) to verify proper radiotelephone receiver
operation.
10. If a response is not heard (full quieting), have the radio unit
inspected at your nearest authorized service center.
11. Press the CHAN
▼ key to tune unit to any channel (except
Channel 16).
12. Set the monitoring transceiver to the same frequency (see
Appendix for operating frequencies).
13. Listen for any activity.
14. If no activity is detected, transmit the test message and have
someone monitor the transmission (see above for suggested test
message formats).
15. If the test signal was not heard (full quieting), have the unit
inspected at your nearest authorized service center.
16. Have someone return the call from the monitoring station
(lowest power setting) to verify proper radiotelephone receiver
operation.
17. If a response is not heard (full quieting), have the radio unit
inspected at your nearest authorized service center.
18. Slide ON/OFF button to turn unit OFF.
19. Replace control panel protective cover.
20. Replace unit into its survival craft package.
VISUAL INSPECTION
Periodically inspect the Survival Radio for damage, cracks and front
panel label wear. Wipe off any salt deposits with a damp cloth.