ACR&Artex 16__6 Survival Radio - Manual (Page 12)

Y1-03-0079-1D 11
4. Listen for the tone and for the squelch action 3 seconds after
activating the unit.
5.
The receiver tunes to Channel 16 automatically when unit is turned
ON.
6.
Listen for any activity on the frequency (channel 16).
7. If no activity is detected, transmit the test message and have
someone monitor the transmission (see above for suggested test
message formats).
8.
If the test signal was not heard (full quieting), replace the battery
and retest. If the test signal is still not heard (full quieting), have the unit
inspected at your nearest authorized service center.
9.
Have someone return the call from the monitoring station (lowest
power setting) to verify proper radiotelephone receiver operation.
10. If a response is not heard (full quieting), have the radio unit
inspected at your nearest authorized service center.
11. Press the CHAN 6 key to tune unit to channel 6.
12. Set the monitoring transceiver to channel 6 (156.3 MHz).
13. Listen for any activity on the frequency (channel 6).
14. If no activity is detected, transmit the test message and have
someone monitor the transmission (see above for suggested test
message formats).
15. If the test signal was not heard (full quieting), have the unit
inspected at your nearest authorized service center.
16. Have someone return the call from the monitoring station (lowest
power setting) to verify proper radiotelephone receiver operation.
17. If a response is not heard (full quieting), have the radio unit
inspected at your nearest authorized service center.
18. Slide ON/OFF button to turn unit OFF.
19. Replace control panel protective cover.
20. Replace unit into its survival craft package.
VISUAL INSPECTION
Periodically inspect the Survival Radio for damage, cracks and front
panel label wear. Wipe off any salt deposits with a damp cloth.