Acnodes RMW 6170 - Manual (Page 4)

RMW 6170
17” 1920x1080 Full HD LCD monitor
6U Rackmount Display Panel
© Copyright 2013 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Ave,
Chino, CA 91710
tel:909.597.7588, fax:909.597.1939
Before Installation
¦
It is ver y im portant to mount the equipment in a suitable cabinet or on a stable surface.
¦
Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessive
dust, dirt, heat, water, moisture and vibration.
Unpacking
The equipment comes with the standard parts shown in package content. Check and make sure they are
included and in good c ondition. If anything is missing, or dam aged, contact the supplier immediately.
How To Clean Your LCD Monitor
Caution :
¦
To avoid the r isk of electric shock, make sure your hands are dr y before unplugging your monitor from or
plugging your m onitor into an electrical outlet.
¦
When you clean your monitor, do not press down on the LCD screen. Pr essing down on the screen can
scratch or damage your display. Pressure dam age is not covered under warrant y.
¦
Use only cleansers m ade specifically for cleaning m onitors and monitor screens. Cleansers not made to
clean monitors and monitor screens can sc ratch the LCD display or strip off the finish.
¦
Do not spray any kind of liquid directly onto the screen or case of your monitor. Spraying liquids directly
onto the screen or case can cause dam age which is not covered under warrant y.
¦
Do not use paper towels or abrasive pads to clean your monitor. Using an abrasive pad or any wood based
paper product suc h as paper towels can sc ratch your LCD screen.
Cleaning Your Monitor
To clean your LCD safely, please follow these steps :
1 Disconnect the power cord.
2 Gently wipe the surfac e using a clean, dr y micr ofiber cloth. Use as little pr essure as possible.
Cleaning Tough Marks and Smudges
To rem ove tough marks and smudges, please follow these steps :
1 Disconnect the power cor d.
2 Spray a small amount of non-abrasive cleanser on a microfiber cloth.
Caution : Do not spray or apply any liquids directly onto the monitor. Always apply the solution to your
microfiber cloth first, not directly on the parts you ar e cleaning.
3 Gently wipe the surface. Use as little pressure as possible.
4 Wait until your monitor is completely dry before plugging it in and powering it up.