Acnodes FES 2215 User Manual

Page 36

Chapter 4: Installation Guide

4-1. Memory Modules (SO-DIMM)

Pipal 2215 provides two 240-pin DDR3 SO-DIMM slots.

- It is NOT allowed to install a DDR or DDR2 memory module into a DDR 3 slot; otherwise, the

motherboard and SO-DIMM may be damaged.

- Please install the memory module from DDR3_A2 slot as the 1

priority.

4-1.1 Installing a SO-DIMM

Please make sure to disconnect the power supply before adding or removing SO-DIMMs or the

system components.

STEP 1: Unlock a SO-DIMM slot by pressing the retaining clips outward.
STEP 2: Align a SO-DIMM on the slot such that the notch on the SO-DIMM matches the break on the slot.

The SO-DIMM only fits in one correct orientation. It will cause permanent damage to the

motherboard and the SO-DIMM if you force the SO-DIMM into the slot in the incorrect orientation.

STEP 3: Firmly insert the SO-DIMM into the slot until the retaining clips at both ends fully snap back in
place

and the SO-DIMM is properly seated.