Acnodes FES 2215 - Manual (Page 22)

Chapter 3: UEFI Setup Utility
3-1 Introduction
This section explains how to use the UEFI SETUP UTILITY to configure yours system. The UEFI chip on the
motherboard stores the UEFI SETUP UTILITY. You may run the UEFI SETUP UTILITY when you start up the
computer. Please press or during the Power-On-Self-Test (POST) to enter the UEFI SETUP
UTILITY, otherwise, POST will continue with its test routines.
If you wish to enter the UEFI SETUP UTILITY after POST, restart the system by pressing + +
, or by pressing the reset button on the system chassis. You may also restart by turning the system off
And then back on.
3-1.1 UEFI Menu Bar
The top of the screen has a menu bar with the following selections:
Main: For setting system time/date information
OC Tweaker: For over-clocking configurations
Advanced: For advanced system configurations
H/W Monitor: Displays current hardware status
Boot: For configuring boot settings and boot priority
Security: For security settings
Exit: Exit the current screen or the UEFI SETUP UTILITY
You
Use < ? > key or key to choose among the selections on the menu bar, and use key or
key to move the cursor up or down to select items, then press to get into the sub screen.
can also navigate with a mouse.
3-1.2 Navigation Keys
Please check the following table for the function descriptions of each navigation keys.