Fes7510 – Acnodes FES 7510 User Manual

Page 68

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com

FES7510

Fanless Embedded Controller comes with

Intel Celeron M ULV Processor

VIA ONCHIP IDE DEVICE:

The options for these items are found in its sub menu. By pressing the

key, you are prompt to enter the sub menu of the detailed options as shown below:

Descriptions on each item above are as follows:

1. OnChip Primary PCI IDE

The integrated peripheral controller contains an IDE interface with support for two IDE channels. Select
Enabled to activate each channel separately.

2. Primary Master/Slave PIO

The four IDE PIO fields allow you to set a PIO mode (0-4) for each of the four IDE devices that the onboard
IDE interface supports. Modes

0 through 4 provide successively increased performance. In Auto mode, the system automatically deter-
mines the best mode for each device.

3. Primary Master/Slave UDMA

Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environ-
ment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If you hard drive
and your system software both support Ultra DMA/33, select Auto to enable BIOS support.

4. On-Chip Serial ATA:

This item controls SATA mode.