When the programme has finished – Candy LMOH VARIO 7 User Manual
Page 21
Putting detergent in machine
D) Open the drawer, choose the detergent
and put in the correct amount,
according to the manufacturer’s
instructions and the detergent advice.
Add any other laundry aids (see page
15). Close the drawer again.
Liquid detergents that are to be placed
directly into the drum should use the
recommended dispensing device.
21
Main w
ash
powder
Pre-w
ash
powder
Fabr
ic conditioner
Selecting the wash programme
Note: when setting the programme, make sure that the
Marcha/Parada button is not depressed.
Refer to the programme guide or the programme descriptions on the front of the
machine to select the most suitable programme.
The programme is selected by turning the programme selector clockwise and
aligning the programme number with the indicator.
Check that the tap is turned on and that the discharge hose is positioned
correctly.
Press the Marcha/Parada button. The Bloqueo Puerta indicator illuminates and
the programme will begin.
Press additional function buttons if you require.
Should it be noticed after commencing the wash cycle that the incorrect
programme has been selected, switch off the machine for a few seconds. After the
time has passed you may then continue to select the desired programme and
resume with the wash cycle.
When the programme has finished
Wait for the door lock to be released (about 2 minutes after the programme has
finished). The neon will go out and you may then switch off. Switch off the
machine by resetting the Marcha/Parada button and open the door by pressing
the Apertura/Puerta button. Remove the laundry. Disconnect the plug from the
mains power supply and turn off the water supply after every use.
C) Put the laundry in the washing machine. Close the door again, ensuring that
no items of laundry are obstructing the lock or door seal.
english final.qxd 23/12/2003 12:00 Page 21