Ab c – Candy GO W164-10S User Manual
Page 6

11
EN
Use the 4 feet to level the
machine with the floor:
a) Turn the nut clockwise to
release the screw adjuster of
the foot.
b) Rotate foot to raise or
lower it until it stands firmly on
the ground.
c) Lock the foot in position
by turning the nut anti-
clockwise until it comes up
against the bottom of the
machine.
Ensure that the knob is on the
“OFF” position and the load
door is closed
Insert the plug.
ATTENTION:
should it be necessary to
replace the supply cord,
connect the wire in
accordance with the
following colours/codes:
BLUE
- NEUTRAL (N)
BROWN
- LIVE (L)
YELLOW-GREEN
- EARTH ( )
After installation, the
appliance must be
positioned so that the plug is
accessible.
A
B
C
SL
Uporabite vse 4 nogice,
zravnate pralni stroj z tlemi
a) Matico, s katero je pritrjena
nogica sprostite tako, da jo
odvijete z
ustreznim kljuãem.
b) Nogico z obraãanjem
zvi‰ujte ali zniÏujte toliko ãasa,
dokler se ne bo povsem
prilegala tlom.
c) Po konãanem izravnavanju
nogico ponovno pritrdite tako,
da jo z ustreznim kljuãem
privijate v smeri nasprotni od
gibanja urinih kazalcev dokler
se povsem ne prileÏe dnu
stroja.
Prepriãajte se, da je gumb
programatorja v izklopljenem
poloÏaju in da so vrata stroja
zaprta.
Vtaknite vtiã v vtiãnico.
POZOR:
ãe je treba zamenjati prikljuãni
elektriãni kabel, prikljuãite Ïice
skladno s spodaj navedenimi
barvami/kodami:
MODRA
- NULA (N)
RJAVA
- FAZA (L)
RUMENA-ZELENA - OZEMLJITEV (
)
Stroj mora biti name‰ãen tako,
da lahko vtiãnico doseÏete v
vsakem trenutku.
10
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
EN
Fix the sheet of corrugated
material on the bottom as
shown in picture.
Connect the fill hose
to the tap.
The appliance must be
connected to the water
mains using new hose-sets.
The old hose-sets should not
be reused.
IMPORTANT:
DO NOT TURN THE TAP
ON AT THIS TIME.
Position the washing
machine next to the wall.
Hook the outlet tube to the
edge of the bath tub,
paying attention that there
are no bends or
contractions along the tube.
It is better to connect the
discharge hose to a fixed
outlet of a diameter greater
than that of the outlet tube
and at a height of min. 50
cm. If is necessary to use the
plastic sleeve supplied.
The appliance must not be
installed behind a lockable
door, a sliding door or a door
with a hinge on the opposite
side to that of the washer
dryer.
SL
Izolacijsko plo‰ão iz
valovitega kartona
namestite na dno stroja
tako, kot je prikazano na sliki.
Dotoãno cev za vodo
privijte na pipo.
Aparat smete prikljuãiti na
vodovodno omreÏje
izkljuãno z novimi, priloÏenimi
dovodnimi cevmi. Starih
cevi ne smete uporabiti.
OPOZORILO!
PIPE ZA VODO ·E NE
ODPRITE!
Stroj potisnite k steni in pri
tem pazite, da dotoãna in
odtoãna cev za vodo nista
zviti ali stisnjeni. Odtoãno
cev za vodo obesite nato
preko robu kadi.
Mnogo bolje pa je, ãe v
vodovodni napeljavi
predvidite stalni odtok, ki
mora biti enakega premera
kot je odtoãna cev,
namestiti pa ga morate v
vi‰ini najmanj 50 cm od tal.
âe je potrebno, namestite
na konec odtoãne cevi ‰e
ãvrsto nosilno koleno, ki je
priloÏeno v vreãki s priborom.
Aparata ne smete postaviti
za vrati, ki se zaklenejo, za
drsnimi vrati ali za vrati, pri
katerih so teãaji na nasprotni
strani od tiste, na kateri stoji
pralo-su‰ilni stroj!