Candy GO W496D-AUS - Manual (Page 4)

“DOOR SECURITY” indicator light
The “Door Security” indicator light is illuminated when the door is fully closed and the machine is ON.
When "Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the “Door Security” light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF" .
B
Door Handle
Press the finger-bar inside the door handle to open the door.
A
6
Description of controls
Door handle A
"Door Security" indicator light B
"Start/Pause" button C
"Stain Vanish" button D
"Allergy Care" button E
"Delay Start" button F
"Temperature Selection" button G
"Drying Selection" button H
"Spin Speed" button I
Digital display L
Stain level button M
Programme selector with “OFF” position N
Buttons indicator light O
Detergent drawer P
7
KG Detector
Available on the Cottons and Synthetics cycles, the intelligent sensor adjusts the water level
and programme length throughout each phase of the cycle according to how much laundry
you load into the machine. The KG Detector indicator will light up when the intelligent sensor
is weighing the laundry.
The washing machine is fitted with a self-adjusting water level system. This system
enables the machine to use the optimum amount of water needed to wash and rinse the
laundry in relation to the particular load. This results in a reduction of the water and electricity
used without in any way compromising the washing and rinsing
performance. The amount of water and electricity used will always be appropriate for the
clothes load size.
The washing machine automatically ensures excellent washing results at minimum cost whilst
respecting the environment.
N
A
P
L I B O M
D E F G H C