Candy GO W496D-AUS - Manual (Page 19)

Note: it is advisable to turn off the tap after each wash
to isolate the washing machine from the water supply.
The appliance must not be installed behind a lockable door, a sliding door or a door with a
hinge on the opposite side to that of the washer dryer.
For the washing machine to function properly the terminal end of the discharge hose (mouth)
must be at a minimum of 50 cm and a maximum of 85 cm from the ground.
Electricity supply and safety advice
Washing machines are supplied to operate at a voltage of 220-240V, 50 Hz single-phase.
Check that the conductor is powerful enough to supply at least 3.0 kW, then connect the plug
to a 16A earthed socket.
After installation,the appliance must be positioned so that the plug is accessible.
Check that the electricity supply to your home has an earthing system.
The socket in your home and the plug on the appliance must be of the same type.
WARNING: Do not use this appliance with a cord extension set, multiple
connector or electrical portable outlet device due to risk of overload,
splashing or ingress of moisture.
All Candy washing machines comply with the safety requirements laid down by the Quality
Trademark Institute.
ATTENTION:
if the power supply cord or plug of this appliance is damaged, it must be replaced by an
authorised Candy service centre or qualified electrician.
37
Note: we recommend you keep the screws to
immobilise the machine for future transit.
The Manufacturers will not be responsible for any
possible damage to the machine caused by not
following the rules relating to releasing the mechanism.
The user is responsible for all costs of installation.
Water connection
The appliance must be connected to the water mains using new
hose-sets.
The old hose-sets should not be re-used.
The machine has an inlet hose with 3/4" B.S.P threaded end
connection to attach between the threaded connector on the
appliance and the cold water supply.
This machine only uses cold water, therefore
only one hose is needed to connect to the cold
water supply. Do not connect to the hot supply.
Cold fill is an energy efficient system. Only the
water required for the washing is heated.There
is no loss of heat in the pipeline from a hot
water tank or boiler to the machine.
36
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm