Plantronics Calisto 540 - Manual (Page 11)

Plantronics P540-M User Guide 11
Note When you are using a computer in another location as a
remote desktop, you cannot access the sound from the remote
computer.
Putting calls on hold
Use the Flash button to put a call on hold:
• When you are currently on a call, pressing the Flash button
puts that call on hold.
• When you are on a call and there is an incoming call, pressing
the Flash button puts the first call on hold and connects you to
the second call.
• When you are on a call and there is another call already on
hold, pressing the Flash button puts the active call on hold and
transfers you to the other call that is previously on hold.
• When there are several calls on hold, pressing the Flash button
circulates the calls to activate in the order starting from the last
active call that was put on hold.
redialing
Press the Redial button to call a previously dialed number:
• When you just completed a call by using your phone, redials
this number.
• When you just completed a call by using Microsoft Office
Communicator, redials this number.
• When you tried to call a number by using the phone, but the
call was unsuccessful, redials this number.
• When you tried to call a number by using Microsoft Office
Communicator, but the call was unsuccessful, redials this
number.
• When you called a contact by using Microsoft Office
Communicator, and then called another contact by using the
phone, redials the number that you called on the phone.
• When you called a contact by using the phone, and
then called another contact by using Microsoft Office
Communicator, redials the number that you called in Microsoft
Office Communicator.
The Redial button calls the last outgoing call made—regardless
if the call was made in Microsoft Office Communicator or the
phone, or if the call did not connect successfully. Note that the
information about the last call made is stored in the computer that
is running Microsoft Office Communicator. So, if you disconnect
the phone from one computer and connect it to another
computer that is running Microsoft Office Communicator, and
then you press the Redial button, the phone will redial the last
number called based on the information stored in the second
computer. If you press Redial and have not previously made
any calls, the phone and Microsoft Office Communicator will not
respond. There will be no action or message displayed.
Changing the Device Settings
You can modify the volume and text display settings of your
phone through Device Settings. Device Settings can be accessed
during the first 10 seconds of the splash screen of the phone
display at startup. The “5=settings” are displayed for 10 seconds.
The display information for the Device Settings is in English only.
If the language setting of Microsoft Office Communicator is not
English, the “5=settings” are not displayed with the splash screen.
However, you can still access Device Settings when you press the
“5” button during the first 10 seconds of the splash screen.
To modify volume and text display, follow the display instructions
after the Device Settings start.
When you are in Device Settings mode, press the “*” button to:
• Return to a previous menu.
• Exit Device Settings.
CaUtioN Do not disconnect the phone from the computer that
is running Microsoft Office Communicator when making changes
to the device settings. Disconnecting while you are changing
device settings could result in data corruption.
to change the volume button response rate settings
The volume button response rate can be changed by following
the steps below. When a volume button is pressed, a timing delay
occurs before increasing or decreasing the volume.
1 After the Device Settings start, press “1” to continue (or “*” to
exit) and then “1” again to continue.
2 Press “1” for volume button settings (or “2” for more options).
You receive the following message: “You can adjust the rate which
volume will increase or decrease when holding down the volume
buttons.” Continue pressing “1” to read through the message.
3 Select a volume press response rate: 1, slow; 2, standard; 3,
fast.
4 Use the volume button response rate?
YES (1) Cancel (*).
5 Volume button press response rate saved.