Other external component operations – JVC KD-G442 User Manual

Page 16

ENGLISH

You can connect an external component to the
AUX (auxiliary) input jack on the control panel.

• You can also select “AUX IN” as the playback

source by pressing the SRC (source) button.

Turn on the connected component and

start playing the source.

Adjust the volume.

⁄

Adjust the sound as you want. (See

page 13.)

To check the other information while
listening to an external component

Other external component operations

Indications

Item

( : Initial)

Selectable settings, [reference page]

SUB.W FREQ

Subwoofer cutoff
frequency

• LOW
• MID
• HIGH

: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.

TAG DISPLAY
Tag display

• TAG ON
• TAG OFF

: Shows the Tag information while playing MP3/WMA tracks, [12].
: Cancels.

AMP GAIN
Amplifier gain control

• LOW POWER

• HIGH POWER

: VOLUME 00 – VOLUME 30 (Select this if the maximum power of the

speaker is less than 50 W to avoid them from damaging the speaker.)

: VOLUME 00 – VOLUME 50

IF BAND
Intermediate
frequency band

• AUTO

• WIDE

: Increases the tuner selectivity to reduce interference noise between

close stations. (The stereo effect may be lost.)

: Subject to the interference noise from adjacent stations, but the

sound quality will not be degraded and the stereo effect will remain.

For KD-G442/KD-G441: Displayed only when “L/O MODE” is set to “SUB.W.”

AUX IN

Ô Clock

3.5 mm stereo mini
plug (not supplied)

Portable audio player, etc

EN08-17_KD-G441_006C_fff.indd 16

4/9/08 4:52:02 PM