JVC DLA-X90 - Manual (Page 37)

Operation
37
ENGLISH
5
Adjust the shift (image position)
BACK
Back
Operate
Select
Shift
Lens Control
● After adjusting the image position, it may be necessary to
select “Pixel Adjust” from the Settings menu “Installation”.
(Reference page: 66 to 67 )
● Every time the
LENS
button is pressed, the adjustment
item will be switched among “Focus”, “Zoom” and “Shift”.
OK It can also be switched with the button.
)RFXV =RRP 6KLIW
LENS
STAND BY
STAND BY
STAND BY/ON
STAND BY/ON
Blinking (Red Lamp)
Light on (Red Lamp)
While a confirmation screen is displayed
Cool Down mode
6
Turn off power source
● When power off, the lens cover will be closed. 90 70
Set the lens cover.
● The power cannot be turned off within approximately 90
seconds after it has been turned on. Start operation only
after 90 seconds time.
● You can also press the button on the unit to turn off
the power. (Reference page: 16)
● Pull out the power plug when the unit will not be used for a
prolonged time.
About Cool Down
mode
MEMO
● The Cool Down mode is a
function to cool down the lamp
for approximately 60 seconds
after projection is complete.
This function prevents the
internal parts of the unit from
deformation or damage due to
overheating of the lamp. It also
prevents lamp blowout and
premature shortening of lamp
life.
● During Cool Down mode, the
[STANDBY/ON] indicator blinks
in red.
● After the Cool Down mode is
complete, the unit automatically
returns to standby mode.
● Do not pull out the power plug
during Cool Down mode. This
may shorten the lamp life and
cause a malfunction.
● The slide cover will not close
if the [Lens Cover] is set to
[Open] in the [3. Installation]
- [3-1. Lens Control] menu.
(Reference page: 66)
LENS
Adjust accordingly
by pressing the
up/down/left/right
buttons
X7 30