JVC KS-BTA200 - Manual (Page 21)

19
Receiving a call
If you receive a call, “Receiving Call (and name,
phone number if acquired)” appears on the display.
Press one of the following buttons.
The source changes to Bluetooth Phone and you can
receive the incoming call.
Type A
Any key (except /ATT, +/–, MAP, SRC and
0.)
Type B/Type C/Type D
Any key (except /ATT and VOL +/–.)
for the Touch Panel model
You can also press the message “Receiving
Call” displayed on the touch panel to receive
a call.
• When another call comes in while talking, see
“Answering a waiting call” on page 23.
To end the call or reject an incoming call, press and
hold one of the above buttons.
Note
You can set the receiver to receive or reject the incoming call
automatically. See “Auto Answer” on page 31.
• Before you use a Bluetooth device with your receiver, connect a Bluetooth device. See “Bluetooth
Connection” on page 12.
• When the sound is stopped or interrupted during the use of a Bluetooth device, try the following
remedies.
• Turn Off, then turn On the power to the receiver.
• (When sound is not yet restored,) Connect the device again. See “Connecting/Disconnecting the
device“ on page 17.
• For details of the menu operations, refer to the instruction manual supplied with your receiver.
• Indications on the display (monitor) and button names vary among the receivers.
ex. SOURCE: SRC
7: 7 / BACK
MENU: AV MENU, AV Menu
Bluetooth Phone: Bluetooth PHONE, BT-PHONE
New Device: New device, NEW DEVICE
Bluetooth Phone Operations
Selecting a source
Before you operate the Bluetooth phone function,
change the source to “Bluetooth Phone.”
for Type A
Press and hold MENU to call up the
Bluetooth menu or press PHONE on the
remote controller.
for Type B/Type C/Type D
Press SOURCE repeatedly to select
“Bluetooth Phone.”
Connection/Bluetooth Phone
KS-BTA200_book.indb 19 KS-BTA200_book.indb 19 06.12.21 5:07:52 PM 06.12.21 5:07:52 PM