HONDA 2008 CR-V Navigation - Manual (Page 71)

Navigation System 71
System Set-up
Set-up Mode
The Setup function consists of two
different screens that allow you to
change and update information in the
system. To display the
Setup screens,
use the voice control system and say
“Setup,” or press the
SETUP button. To
change it to another Setup screen, say or
select
More in the upper right corner of
the screen.
On any of the Setup screens, you can
use the voice control system to select
any item on the screen.
NOTE:
• If some items appear to be grayed
out, and cannot be selected, it is
because you did not select
OK on the
initial Disclaimer screen. See
System Start-up on page 16 .
• For information on the available
voice commands, see Voice
Command Index on page
131 .
Setup Screen (first)
From any screen, say “Setup” or press
the
SETUP button, and the following
screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say “Brightness up”
or “Brightness down.” You can also
select the
Bright. bar and move the
cursor by pushing the joystick left or
right, or by touching the arrowhead in
the bar.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
NOTE:
You can have a separate daytime and
nighttime setting for brightness. Adjust
each setting when the display is in either
daytime or nighttime mode.
Volume
The navi voice volume is adjustable in
10 steps, and also can be turned off. To
adjust the volume, use the voice control
system and say “Volume up” or
“Volume down.” You can also select the
Volume bar and move the cursor by
pushing the joystick left or right, or by
touching the arrowheads in the bar.
After adjusting the volume, you will
hear beeps at the new volume level. You
can also select volume off.
NOTE:
If you turn the volume off, you will not
hear route guidance or voice command
confirmations.
2008 CR- V
Main Menu