FIAT Barchetta - Manual (Page 91)

90
3) Screw up the bolts with the span-
ner provided.
4) Lower the vehicle and remove the
jack.
5) Tighten up the bolts in the same
order as shown above.
When you have finished
1) Put the space-saver spare wheel
back in the boot.
2) Put the jack back in its support
making sure pin A-fig. 8 coincides
with jack groove B then place the unit
in the wheel that has been changed.
3) Put the tools you have used back
in their support.
4) Position the support making slot
A-fig. 9 coincide with the base of the
jack.
5) Do up clamp B.
REFITTING
THE STANDARD WHEEL
1) Following the above procedure,
raise the car and remove the space
saver wheel.
2) Assemble the normal use wheel.
If the wheel is fitted with a hub cap, it
is necessary to add only one bolt first,
then assemble the hub cap by aligning
the hole A-fig. 7 with the already as-
sembled bolt, screw on the other
three bolts, using the extension B for
fitting the fixing bolts.
fig. 7
P5S00696m
fig. 8
P5S00695m
fig. 9
P5S00682m