FIAT Croma User Manual

Page 165

164

ARNING

LIGHTS AND MESSAGES

CAR

TECHNICAL

INDEX

DASHBOARD

AND

SAFETY DEVICES

CORRECT USE OF THE CAR

IN AN

EMERGENCY

For versions with alloy rims
❒ Insert the wheel on the hub and, using

the wrench provided, tighten the
bolts.

❒ Lower the car and remove the jack.
❒ Using the wrench provided, fully tigh-

ten the bolts in the sequence shown
in fig. 10;

❒ insert the logo holder by pressing on

the exterior side.

When you have finished
❒ Place the spacer.
❒ Fit the jack partially open in its con-

tainer C-fig. 11 forcing it lightly to
prevent it from vibrating when travel-
ling.

❒ Put the tools back into their places in

the container.

REFITTING THE STANDARD
WHEEL

Following the procedure described previ-
ously, raise the car and remove the spare
wheel.

For versions with steel rim

Proceed as follows:
❒ make sure the contact surfaces be-

tween standard wheel and hub are
clean so that the fastening bolts will
not come loose;

❒ fit the standard wheel by inserting the

first bolt for two threads into the hole
closest to the inflation valve;

❒ using the wrench provided, tighten the

fastening bolts;

❒ lower the car and remove the jack;
❒ using the wrench provided, fully tight-

en the bolts in the sequence shown
previously;

❒ fit the wheel cap making the groove

(on the wheel cap) coincide with the
inflation valve.

fig. 11

F0L0219m

fig. 10

F0L0368m

157-192 Croma TRW GB 28-09-2007 14:14 Pagina 164