MITSUBISHI ELECTRIC MDT701S - Manual (Page 57)

English-53
English
OFF H MIRROR
Horizontally
rotated
V MIRROR
Vertically
rotated
180 90L 90R
90 degree
rotation
270 degree
rotation
180 degree
rotation
OSD screen functions (continued)
CONFIGURATION2

SERIAL CONTROL
Select the communication interface (RS-232C, OPS (OPS-
compliant computer), or LAN) for the serial communication
function.
For connection of the signal cable, see page 24 to 28.

LAN SETTING
You can set the communication parameters for the LAN
network.
DHCP CLIENT
Select whether to use DHCP client or not.
Select OFF when not using it, and select ON when using
it.
IP ADDRESS
When DHCP CLIENT is OFF, set the IP address of the
monitor.
When DHCP CLIENT is ON, you can check the value set
by the DHCP server.
SUBNET MASK
When DHCP CLIENT is OFF, set the gateway mask. Set it
to 255.255.255.0 for normal use.
When DHCP CLIENT is ON, you can check the value set
by the DHCP server.
DEFAULT GATEWAY
When DHCP CLIENT is OFF, set the IP address of the
gateway router to externally connect the local area
including the monitor.
When DHCP CLIENT is ON, you can check the value set
by the DHCP server.
PORT
The port number (3007 and 63007) of the monitor is
displayed.
RESET
LAN settings are reset.

CONTROLLER SETTING
When controlling the monitor via a network using a 2-Series
control processor made by Crestron, set the communication
parameters.
CONTROLLER IP
Set the IP address of the control processor.
PORT NUMBER
Set the port number used for communication.
IP ID
Set the IP identifi cation number.
NOTE: For the detailed setting procedures, see the
operation manual of the control processor made by
Crestron.

CONTROL TIME OUT
When using remote control, the timeout for transmission
intervals among codes within the control command can be
set.
10 ms: Set the time out intervals to 10 milliseconds.
2 s:
Set the time out intervals to 2 seconds.
30 s: Set the time out intervals to 30 seconds.

MONITOR ID
ID numbers for wireless remote control are assigned to
MDT701S monitors that are multi-connected via RS-232C.
ID numbers 1 to 26 are selectable.

OSD TURN OFF
The OSD control menu will stay on as long as it is used.
The preset choices are 5 -120 seconds.

OSD H POSITION
You can adjust the horizontal position of the OSD menu.

OSD V POSITION
You can adjust the vertical position of the OSD menu.

OSD ROTATION
The OSD screen is rotated.