MITSUBISHI ELECTRIC MDT701S - Manual (Page 25)

English-21
English
DVI-D IN
HDMI1 IN or HDMI2 IN
DP IN
AUDIO ANALOG IN
HDMI cable
DisplayPort cable
DVI-D cable
DVI-D cable
To DVI-D output
To HDMI output
To DP output
To audio output
Audio cable
(ø3.5-mm stereo mini)
DVI-D IN
DVI-D OUT
Audio cable
(ø3.5-mm stereo mini)
AUDIO ANALOG OUT AUDIO ANALOG IN
Personal computer
(DVI-D, HDMI)
Connecting with a computer (digital connection)
Digital connection:
• Connection via the HDMI IN connector
(1) Connect an HDMI cable (commercially available) to the HDMI1 IN or HDMI2 IN connector.
(2) Select [HDMI1] or [HDMI2] according to the connected connector by pressing the INPUT button on the monitor or the HDMI1
or HDMI2 button on the wireless remote control.
• Connection via the DVI-D IN connector
(1) Connect a DVI-D cable (commercially available) to the DVI-D IN connector.
(2) Select [DVI-D] using the INPUT button on the monitor or the DVI-D button on the wireless remote control.
• Connection via the DISPLAYPORT IN connector
(1) Connect a DisplayPort cable (commercially available) to the DISPLAYPORT IN connector.
(2) Select [DISPLAYPORT] using the INPUT button on the monitor or the DISPLAYPORT button on the wireless remote control.
Second monitor connection:
• Connect the DVI-D OUT connector on the fi rst monitor and the DVI-D IN connector on the second monitor using a DVI-D cable
(commercially available).
NOTE:
• In the daisy chain connection, you can connect up to 4 monitors (when using 2-meter cables). However, the maximum number
of connectable monitors may be limited. It is recommended to check the number of connectable monitors in advance in your
installation environment.
• Set RGB of POWER SAVE in the CONFIGURATION1 menu to OFF when using DVI-D in the daisy chain mode.
Audio connection:
• Connect an audio cable (ø3.5-mm stereo mini) (commercially available) to the AUDIO ANALOG IN connector.
When connecting an HDMI cable, select [HDMI1] or [HDMI2] according to the connected connector by pressing the INPUT
button on the monitor or the HDMI1 or HDMI2 button on the wireless remote control. Note that you can select HDMI1, HDMI2, or
ANALOG audio at this time. (You can select HDMI audio only when the video input is [HDMI1] or [HDMI2]. The audio of only the
selected input is output and HDMI is displayed.)
When connecting a DVI-D cable, select [DVI-D] using the INPUT button on the monitor or the DVI-D button on the wireless
remote control. At the moment of the selection, the audio is automatically switched to [ANALOG].
When connecting a DisplayPort cable, select [DISPLAYPORT] using the INPUT button on the monitor or the DISPLAYPORT
button on the wireless remote control. Note that you can select DISPLAYPORT or ANALOG audio at this time.
• To output the audio to the second monitor, connect the AUDIO ANALOG OUT connector on the fi rst monitor and the AUDIO
ANALOG IN connector on the second monitor using an audio cable (ø3.5-mm stereo mini) (commercially available).
Even when HDMI or DISPLAYPORT is selected on the fi rst monitor, the selected audio is output from the AUDIO ANALOG OUT
connector.
NOTE:
• For switching the audio input when an HDMI cable or a DisplayPort cable is connected, see “Audio input change.”
P-4 Connection procedure (continued)
LCD monitor (second monitor)
LCD monitor (fi rst monitor)
LCD monitor
(fi rst monitor)
LCD monitor
(second monitor)