MITSUBISHI ELECTRIC MDT701S - Manual (Page 33)

English-29
English
Connecting the power source
Before making connections
• Check that the main power switch is off.
CAUTION:
When an OPS-compliant computer is installed and the main power switch of the monitor is on, connecting the power source
may cause the computer to power on, causing damage or breakdown of the operation system and the hard disc.
• The power outlet socket should be installed as near the equipment as possible and should be easily accessible.
NOTE:
Please refer to “Safety Precautions, Maintenance & Recommended Use” in this manual for proper selection of the AC power cord.
Use the clamper to prevent accidental disconnection of the power cord.
1. Insert the power connector of the power cord fully and
fi rmly into the AC IN connector of the monitor.
2. Secure the power connector using the cable holder
(accessory).
CAUTION:
Don’t insert the cable holder into the power outlet
socket. Doing so may cause electric shock.
Fit both ends of the cable holder to the monitor.
Engage the cable holder in Parts A.
Secure the power connector with the cable holder.
3. Secure the power cord using the clamper (accessory).
4. Insert the power plug into the power outlet socket.
• Fully insert the prongs into the power outlet socket.
Loose connection may cause noise.
• Don’t plug and unplug the power cord repeatedly in
a short time of period.
P-9 Connecting the power cord to the monitor
Main power switch
Cable holder (accessory)
Power connector
Power cord (For EU)
Power cord (For North America)
Clamper (accessory)