Connecting cables – Eizo FlexScan S1932 User Manual
Page 6
4
English
Troubleshooting
Setting/Adjustment
Prior to use
Installation
Connecting Cables
Attention
• When replacing the current monitor with a S1932 monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the S1932 monitor referring to the
resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User’s Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Connectors on
the PC
DVI connector
USB Downstream
Connectors on
the monitor
DVI-D connector
USB Upstream
Stereo mini jack cable (supplied)*
1
EIZO USB cable MD-C93 (supplied)*
2
CD player, etc
Signal cable FD-C39 (supplied)
Audio output
connector
Audio input
connector
Digital connection
Connectors on
the PC
D-Sub mini 15-pin
connector
USB Downstream
Connectors on
the monitor
D-Sub mini 15-pin
connector
USB Upstream
Stereo mini jack cable (supplied)*
1
EIZO USB cable MD-C93 (supplied)*
2
CD player, etc
Signal cable MD-C87 (supplied)
Audio output
connector
Audio input
connector
Analog connection
*
1
Required to use the speaker of the monitor (page 6).
*
2
Required when performing the monitor adjustments using the ScreenManager Pro for LCD software. (Refer to
the User’s Manual on the CD-ROM.)
3
Plug the power cord into a power outlet and the Power connector on the monitor.