STIEBEL ELTRON CNS U с 01.03.2010 - Manual (Page 16)

Ĝō ’CZ ZŎe qqqĪZ`.
<é<`VHCĪHB
.CZ`<<`.HC
`VHe
2 Wall mounting bracket
2
6
_0
7
_3
1
_0
1
2
7
1
2
3
1 Appliance
2 Safety cap
3 Locking bolt
9.3 Dismounting the appliance
» Remove the safety cap from the locking bolt.
2
6
_0
7
_3
1
_0
1
2
8
1
2
3
1 Appliance
2 Safety cap
3 Locking bolt
» Undo the locking bolt on the wall mounting bracket.
» Lift the appliance up slightly and pull it forwards and away from
the wall mounting bracket.
9.4 Power supply
» Ensure the on-site supply cable has an adequate cross-section.
» Ensure a socket or junction box for a permanent power supply
is installed at a distance of at least 10 cm from the side of the
appliance.
DANGER Electrocution!
Carry out all electrical connection and installation
work in accordance with relevant regulations.
DANGER Electrocution!
The appliance must be able to be separated from the
mains power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
DANGER Electrocution!
Do not install the appliance with a fixed power cable.
Observe the type plate. The specified voltage must
match the mains voltage.
10. Troubleshooting
The power cable must only be replaced by a contractor using our
original spare parts.Appliance handover
11. Appliance handover
Explain the functions of the appliance to the user. Draw special
attention to the safety information. Hand the operating and
installation instructions to the user.