Edimax Technology IC-3100W - Manual (Page 13)

12
1.6 Camera Installation
Please follow the following instructions to set your Network Camera up.
1. Unpack the product package and check if anything’s missing.
2. Connect the Ethernet cable to your local area network, and connect the
other end to the LAN jack of this Network Camera.
NOTE: You can skip this step if you plan to use wireless LAN only.
3. Plug the power adapter to wall socket, and connect the power connector to
the power jack located at the bottom of the Network Camera.
4. Connect two antennas to the antenna bases, which is located at the back of
this Network Camera.
5. Place the camera at a secure place, and point the camera to the place you
wish to monitor. If you wish to hang the camera on the ceiling or wall,
please use the tripod connector (located at the bottom of the camera) to
secure the camera.
6. Launch Internet Explorer on your computer, and following the instructions
given in next section to set the Network Camera.