Hoover FREEJET FJ180B2 011 - Manual (Page 4)

4
USING YOUR CLEANER
Main cleaner
1. Turn the cleaner on by pressing the On/Off button. [1B]
2. Set the On/Off Turbo switch to the desired cleaning mode. [1C]
CARPET: Switch Turbo Nozzle ON (LED will be ON.)
HARD FLOOR: Switch Turbo Nozzle OFF (LED will be OFF.)
Handheld Cleaner
1. Press the Push and Go button and lift the handheld unit from the cleaner main body. [6]
2. Turn the handheld cleaner on by pressing the On/Off button. [2N]
ACCESSORIES
Rigid Extension Tube*, Crevice Tool and Dusting brush
All accessories are stored at the rear of the charger. All fit directly onto the handheld unit.
CLEANER MAINTENANCE
Emptying the Dust Container
Hold the unit over a bin and pull the bin empty trigger [2O] to instantly empty the dust container. [7]
Cleaning the Filters
1. Release the handheld unit from the main body of the cleaner.
2. Press the filter access button [2P] and remove the handle section from the dust container. [8]
3. Use the filter handle to remove the filter and filter screen from the dust container. [9]
4. Wash the filter and screen in hand warm water. Once thoroughly dry return to the dust container.
5. Reassemble the handheld unit and return to the cleaner main body.
Note: Do not use hot water or detergents when cleaning the filters. In the unlikely event of the filters becoming damaged,
fit a genuine Hoover replacement. Do not try and use the product without a filter fitted.
Changing the Agitator
1. Using a coin turn the lock to the open position. [10]
2. Remove the agitator retainer.
3. Unloop the belt and lift the agitator out of the cleaner. [11]
4. Loop the belt aound the new agitator and return to its original position. Replace the agitator retainer and lock in
place.
End of Product Life Battery Disposal
If the cleaner is to be disposed of the batteries should be removed. Used batteries should be taken to a recycling station
and not disposed with household waste.
IMPORTANT: Always fully discharge the batteries before removal.
1. Run the unit until the batteries run flat.
2. Release the handheld unit from the main body of the cleaner.
3. Press the filter access button and remove the handle section from the dust container.
4. Remove 6 screws and open the unit. [12]
5. Remove the motor/battery housing and disconnect the cables.
6. Remove the batteries from the housing.
Note: Should you experience any difficulties in dismantling the unit or for more detailed information about treatment,
recovery and recycling of this product, please contact your local city office, your household waste disposal service.
GB
* Features vary according to model
0565 5332 Freejet 3 in 1 IM 16 langs.indd 4 30/07/2010 12:53:13