Danfoss AME 140 H - Manual (Page 4)

4
Installation Guide AMV 130(H), AMV 140(H)
DH-SMT/SI VI.KU.L2.9O Danfoss Heating
ENGLISH
Safety Note
To avoid injury and damage to persons
and devices, it is absolutely necessary
these instructions are carefully read
and observed prior to assembly and
commissioning.
Necessary assembly, start-up, and
maintenance work must be performed
only by qualified, trained and authorized
personnel.
Prior to assembly and maintenance work
on the controller, the system must be:
- depressurised
- cooled down
- emptied
- cleaned
Please comply with the instructions of the
system manufacturer or system operator.
Do not remove the cover before the power
supply is fully switched off.
Disposal instruction
This product should be
dismantled and its
components sorted, if
possible, in various groups
before recycling or disposal.
Always follow the local disposal
regulations.
Mounting ❶
The actuator should be mounted with the
valve stem in either horizontal position or
pointing upwards. The actuator is fixed to
the valve body by means of a ribbed nut
which requires no tools for mounting. The
ribbed nut should be tightened by hand.
Wiring ❷
Grey
Black
Red
Stem down
Common
Stem up
24 V
Black
Blue
Brown
Stem down
Common
Stem up
230 V
Do not touch anything on the PCB! Lethal
voltage!
Installation ❸
1. Check the valve neck. The actuator
should be in steam up position (factory
setting). Ensure that the actuator is
mounted securely on the valve body
2. Wire the actuator according to the
wiring diagram
3. The direction of stem movement can be
observed on the position indicator ①
Manual override
(for service purposes only)
Do not manually operate the drive if
power is connected!
AMV 130, AMV 140 ❹
① Remove cover
② Insert the Allen key 6 into the spindle
③ Press and hold the button (on the
bottom side of the actuator) during
manual override
④ Pull out the tool
⑤ Replace cover
Remark:
A ‘click’ sound after energising the actuator
means that the gear wheel has jumped into
normal position.
AMV 130H, AMV 140H ❺
Press and hold the button ① (on the
bottom side of the actuator) during
manual override.
Remark:
A ‘click’ sound after energising the actuator
means that the gear wheel has jumped into
normal position.