Dremel Клеевой пистолет DREMEL 920 - Manual (Page 5)

5
GENERAL SAFETY INSTRUCTIONS
WORKING SAFELY WITH THIS UNIT IS
POSSIBLE ONLY WHEN THE OPERATING
AND SAFETY INFORMATION ARE READ
COMPLETELY AND THE INSTRUCTIONS
CONTAINED THEREIN ARE STRICTLY
FOLLOWED.
• If the cable is damaged or cut through while
working, do not touch the cable but immediately
pull the mains plug. Never use the unit with a
damaged cable.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualifi ed persons in order to avoid a
hazard.
• The unit must not be damp and must also not be
operated in damp surroundings.
• For indoor use only.
• Connect units that are used outdoors by means
of a fault current protection switch (FI) with a
maximum triggering current of 30 mA. Use only
an extension cable that is approved for outdoor
use.
• Always direct the cable to the rear away from
the unit.
• For pauses in the work of more than
30 minutes, pull the mains plug.
• This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• Dremel is able to ensure fl awless functioning of
the unit only if the original accessories intended
for it are used.
• Do not work materials containing asbestos
(asbestos is considered carcinogenic).
• Take protective measures when during work
dust can develop that is harmful to one's
health, combustible or explosive (some dusts
are considered carcinogenic); wear a dust
mask and work with dust/ chip extraction when
connectable.
• Do not change nozzles while glue gun is in
"on" position, plugged in, or warm to the touch.
Before changing nozzles, make sure glue gun is
cool to the touch, unplugged, and the switch is
in the "off" position.
ENVIRONMENT
DISPOSAL
The unit, accessories and packaging should be
sorted for environment-friendly recycling.
ONLY FOR EUROPEAN COUNTRIES
Do not dispose of power tools into
household waste! According to the
European Guideline 2002/96/EC for Waste
Electrical and Electronic Equipment and its
implementation into national right, power
tools that are no longer usable must be
collected separately and disposed of in an
environmentally correct manner.
SPECIFICATIONS
GENERAL SPECIFICATIONS
Description: Dremel Glue Gun
Model number 910 920 930 940
Glue temperature
• low (LO) - 105°C 105°C -
• high (HI) 165°C - 165°C 195°C
Glue stick Ø 7 mm 7 mm 7 mm 11/12 mm
Protection Class /II /II /II /II
EXTENSION CORDS
Use completely unrolled and safe extension cords
with a capacity of at least 5 Amps.
ASSEMBLY
GENERAL
The glue gun is intended for the quick gluing of
clean, dry and grease-free materials with glue
heated to its melting point.
GB
2610399275-GlueGun-EU-0610.indb 5 10399275-GlueGun-EU-0610.indb 5 3-6-2010 12:47:04 3-6-2010 12:47:04