Option menu, Wireless menu – 3M MP8790CN User Manual

Page 32

OPTION Menu

With the OPTION menu, the five items shown in the Table below can
be performed.
Please perform each operation in accordance with the instructions in
the Table.

WIRELESS Menu

The WIRELESS menu is only enabled if the wireless function is enabled. Using the
wireless function requires a Wireless & Network Module Terminal (sold separately). See
the Wireless & Network Module Terminal user’s manual for more information about the
WIRELESS menu. Contact your local dealer for more information about the wireless
function and Wireless & Network Module Terminal.

: SELECT

MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
WIRELESS

VOLUME
WHISPER
IR REMOTE
LAMP TIME
FILTER TIME

Item

Description

VOLUME

Adjust Volume: High

Low

WHISPER

Select WHISPER Mode:
NORMAL

WHISPER

When WHISPER is selected the WHISPER mode is activated. In the WHISPER
mode, acoustic noise and screen brightness are reduced.

IR REMOTE

Selecting the remote control receiver:
The unit has 3 remote control receivers, as shown in the figure
to the right (1, 2, and 3). You can select which of them to
activate (“v” in the figure), and which to disable.
• The ambient lighting and other factors may prevent the

remote control operation from functioning properly. If this
happens, use this function to disable receivers being
impacted by unneeded light.

LAMP TIME

Refer to LAMP TIME: When set, this function displays the total time the
projector lamp has been used since new.
Reset LAMP TIME [Use this function only when the lamp has been replaced!]:
Depress the RESET button for at least 3 seconds while lamp time is being
displayed. The reset menu will then appear. After you replace the lamp with a
new lamp, select RESET on the menu with the

button.

• Do not reset the lamp time unless you have replaced the lamp. And, always

reset the lamp time when replacing the lamp. The message functions will not
operate properly if the lamp time is not reset correctly.

• Before replacing the lamp, carefully read the descriptions headed "THE LAMP".

FILTER TIME

Refer to FILTER TIME: This function displays the total time the air-filter has
been used since new.
Reset FILTER TIME [Use this function only when the filter is cleaned or replaced!]:
Depress the RESET button for at least 3 seconds while lamp time is being
displayed. The reset menu will then appear. After you replace the filter, select
RESET on the menu with the

button.

RESET

CANCEL

• Do not reset the filter time unless you have cleaned or replaced the filter. And,

always reset the filter time when cleaning or replacing the filter. The message
functions will not operate properly if the filter time is not reset correctly.

• Before cleaning or replacing the filter, carefully read the descriptions headed "THE AIR FILTER".

Example : OPTION Menu

(VOLUME)

OPTION Menu