3M MP8790CN - Manual (Page 18)

17
1
Press the STANDBY/ON button (control
panel or remote control)
The message "Power off?" will appear on the screen for
approximately 5 seconds.
3
Check that the STANDBY/ON indicator
stops blinking and lights to
solid orange.
Switch the power switch to
[O] (OFF).
4
Confirm that the STANDBY/ON indicator has
gone off and then attach the lens cap.
When the projector has completed powering down, the
STANDBY/ON indicator will go off.
TURNING OFF THE POWER
2
Press the STANDBY/ON button again
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?"
message is visible. The projector lamp goes off and starts cooling
down. While cooling, the STANDBY/ON indicator flashes orange.
When in this state, pressing the STANDBY/ON button has no
effect.
When lamp cooling is complete, the STANDBY/ON indicator stops
flashing, and turning solid orange.
• Except in cases of
emergency, do not turn off
the power switch while the
STANDBY/ON indicator is
solid or flashing green.
Doing so could shorten
the lamp lifetime.
NOTE
Control panel
STANDBY/ON
STANDBY/ON
STANDBY/ON VIDEO
UP
DOWN
BLANK
ASPECT
PUSH
LASER
INDICATOR
LASER
RGB
FOCUS
ENTER
ON
OFF
ESC MENU RESET
POSITION
MAGNIFY VOLUME
MUTE
WIRELESS KEYSTONE
FREEZE
ONE TOUCH
AUTO PinP
ZOOM PAGE
STANDBY/ON indicator
power switch