Lamp replacement – 3M 9000PD User Manual
Page 33
![background image](/manuals/231582/33/background.png)
33
3M™ Digital WallDisplay
© 3M 2005. All Rights Reserved.
Maintenance
Lamp Replacement
1. Turn the power off and disconnect the power cord from the
outlet.
2. Allow approximately 45 minutes for the lamp to cool, if
necessary.
3. There are two indentations behind the top of the facade, near
each end. Grasp facade plate at each indentation and pull out
and down to remove plate.
Facade
4. Loosen the self-contained screw at the upper righthand corner
of the lamp housing door with a standard screwdriver.
5. Two black wires connect to the lamp cartridge by a black
plastic receptacle on the right side of the lamp cartridge.
Lamp
Cartridge
Receptacle
Black
Wires
See also other documents in the category 3M Projectors:
- Super Close Projection System SCP716 (6 pages)
- S40 (40 pages)
- MP7720 (34 pages)
- MP8630 (28 pages)
- MP7630B (36 pages)
- S50C (41 pages)
- MP8725 (33 pages)
- MP8650 (32 pages)
- MP8640 (28 pages)
- 1700 (9 pages)
- MP8747 (44 pages)
- 9600 (28 pages)
- S15 (55 pages)
- MP8749 (41 pages)
- MP8670 (38 pages)
- Digital Projector X15 (55 pages)
- MP8750 (26 pages)
- 1800 Series (8 pages)
- X66 (2 pages)
- X80 (49 pages)
- MP8790CN (44 pages)
- S50 (2 pages)
- MP8760 (35 pages)
- 9800 (15 pages)
- MP8740 (34 pages)
- MP7730 (40 pages)
- MP8770 (39 pages)
- MPro110 (20 pages)
- DX60 (2 pages)
- X68 (51 pages)
- X75 (57 pages)
- MP8745 (39 pages)
- X40C (40 pages)
- S10 (45 pages)
- PX5 (95 pages)
- MP8620 (32 pages)
- SCP740 (58 pages)
- MP8790 (44 pages)
- MP8660 (38 pages)
- MP8610 (37 pages)
- S10C (45 pages)
- MP7760 (36 pages)
- MP8770/MP8770L (28 pages)
- MP7640i/MP7740i (40 pages)