Arcam AVR360 - Manual (Page 21)

e-21
english
using Zone 2
Zone 2 provides the option for the occupants of the
master bedroom, conservatory, kitchen, etc. to view or
listen to a different source at a different volume level
from the main zone (Zone 1).
Source selection and volume control for Zone 2 is
achieved either by using an Ir receiver in Zone 2 (see
“Zone 2 control connections” on page E-46) or by switching
over to Zone 2 control by pressing the front panel zone
button or by pressing AMP followed by SHiFT then Ok
on the remote control. The front panel VFD display
indicates that control has been switched to Zone 2.
S T A N D B Y Z 2 5 0
D O L B Y T R U E H D 5 . 1
To turn on Zone 2, press the Zone button (or shift+ok)
then press the standby power button on the remote
control. Press a source select button to select a different
source to Zone 1.
F O L L O W Z 1 Z 2 5 0
D O L B Y T R U E H D 5 . 1
note that Zone 2 control from within Zone 1 will pass
automatically back to Zone 1 control after a few seconds
of inactivity.
Zone 2 can also be controlled using a third-party
programmable remote control or a home automation
system. Please contact your dealer or installer for further
details.
extended front panel menu
Pressing the MENU key and holding it for longer than
four seconds will bring up the Extended Menu, allowing
you to perform the following:
Restore to factory defaults
This option allows you to restore all settings on your
AVr360 to the defaults that it left the factory with.
change remote code
The default rC5 system code the AVr360 responds to
is 16. If required, for example due to another device in
your system also using this rC5 system code, it can be
changed to 19.
Restore secure backup
This option allows you to restore all settings to their
state as saved using the ‘Store secure backup’ feature.
This option is useful if settings are accidentally changed.
It also allows the unit to be returned to the saved state
following a firmware update.
Store secure backup
This option allows you to save all the AVr360 settings to
a secure area of memory. The settings can be retrieved
using the restore option above.
– Enter PIN
Enter the secure backup PIn using the ', ,, <
and > keys on the remote control (do not use the
numeric keypad). The default PIn is 1234.
– Change PIN
Allows the PIn to be changed to a number other
than the default. Enter the current secure backup
PIn using the ', ,, < and > keys on the
remote control (do not use the numeric keypad).
The default PIn is 1234. After the current PIn has
been entered correctly, enter a new PIn as prompted
and again to confirm.
– EXIT
Cancel and return to the extended menu.
updating firmware via uSb
The firmware in your AVr360 can be updated using a
USB flash drive containing a firmware update file.