beautypg.com

Arcam AVR360 User Manual

Page 11

background image

e-11

english

Zone 2 connectors

The Z2 out analogue audio connector can be used

to connect the stereo audio output of the AVr360

to an amplifier located in a second room. Connect

the analogue video output to your Zone 2 display

equipment. See ‘Multi-room Setup’ on E-46 for

information.

S-Video and composite

connectors

AV, VCR, BD, SAT
Connect these inputs to the S-Video and Composite

outputs of your available source equipment.

component/Rgb video

connectors

These inputs are suitable for connection to source

devices which output Component (YUV or YPbPr) or

rgB high quality analogue video signals. These signals

are usually available from BD players, set-top boxes or

games consoles.
If you are connecting up to an rgB source you may also

need to connect the source’s Composite output to the

AVr360 Composite input to act as a video sync (‘rgB

+ Sync’ format). The Composite signal should be on the

same named input as the rgB signals. The AVr360 is

also compatible with ‘Sync on green’ or ‘rgsB’ signals.
rgB video outputs on source equipment are often on

SCArT connectors. You will need to use a SCArT to

‘rgB+Sync on phono’ breakout cable, available from

your Arcam dealer.

NOTE
When setting up the AVr360 menus (later in

this manual), you will need to select whether the

three-wire high quality video input is Component

(‘normal’), ‘rgsB’ or ‘rgB + Sync’ for each input.

This is done on the ‘Component Mode’ line in the

Input Config menu. Failure to do this can result in a

green looking picture or a picture that is unstable.

COMPONENT VIDEO IN SAT, AV, BD
Connect the Component video outputs of your source

equipment to these inputs.

COMPONENT VIDEO OUT
Connect this output to the Component video input of

your display device.

digital audio connectors

VCR, PVR, BD, CD, AV, SAT
Connect these inputs to the digital outputs of your

available source equipment.

NOTE
Analogue rgB video output is not available from

the AVr360. The analogue three-wire high quality

video output is always configured as Component

video.