3. projector power down, 4. using system menus, 3. p – 3M MP8610 User Manual

Page 12: Rojector, Ower, 4. u, Sing, Ystem, Enus



Multimedia Projector MP8610



3M 1998

4-3. Projector Power Down

Press the Standby button to place the projector in the standby mode. The cooling fan motor will continue
to run.

Note

Switching the power off before the fan has cycled
off, will decrease the life of the projection lamp.

Wait until the cooling fan motor cycles off then press the main power switch to Off.

Turn off the power to your input devices.

To transport the projector, disconnect the power cord, computer cable, mouse cable and audio/video
cables. Fully retract the projection lens to protect it during transport.

4-4. Using System Menus

You can use the control panel buttons (Figure 3-3) or the remote control (Figure 5-1) to access menus,
exit menus and set menu options. At the top of each menu is a help window, which displays messages
that pertain to the menu item that is highlighted.

Press the up/down or left/right ARROW KEYS on the control panel or move the DISC PAD on the
remote to navigate through the submenus and select menu items.

ÅÆ

Enter

for setup sub

Menu clear

Setup

Option

Audio

Data

VESA 800 x 600 60 Hz
Sync

Brightness

Tracking 1056

Contrast

H. off.

Inverse off

V. off.

Pix. 800x600

Help

Window

Setup

Submenu

1. Press the MENU button to display the main

menu.

2. Press the up/down ARROW KEYS or move

the DISC PAD up/down to choose a sub-
menu.

3. Press the ENTER button to select the sub–

menu.

4. Press the up/down ARROW KEYS or move

DISC PAD to select a menu item in the sub-
menu.

5. Press the left/right ARROW KEYS or move

the DISC PAD left/right to change the value
of a menu item.

6. Press the ENTER button, if required, to

confirm the change to the menu item.

Note

When the background of the displayed item turns
red, you must press the ENTER button to confirm
the change.

7. Press the MENU button to exit the sub-

menu and return to the main menu.

8. In some cases, a message will display in the

help window asking you to confirm the
changes made in the sub-menu. Press
ENTER to confirm.

9. Press the MENU button to exit the main

menu display and return to the projected
image.