Yamaha YJ125T - Manual (Page 59)

6-25
1
2
3
4
5
6
7
8
9
PERIODIC MAINTENANCE AND MINOR REPAIR
To change the engine oil and clean
the oil strainer
1
ZAUM00**
1. Oil filler cap
1. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove panel A. (See page 6-6.)
4. Remove the engine oil filler cap and
drain bolts to drain the oil from the
crankcase.
4 3 2 1
1
ZAUM00**
1. Drain bolt B
2. O-ring
3. Spring
4. Strainer
6.Check the O-ring for damage and re-
place it if necessary.
7. Install the oil strainer, spring, O-ring
and engine oil drain bolts, and then
tighten the drain bolts to the speci-
fied torque.
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3m • kgf, 16.6ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2m • kgf, 23.1ft • lbf)
1
ZAUM00**
1. Drain bolt A
ECA10410
c C
When removing the engine oil drain
bolt, the O-ring, spring, and oil
strainer will fall out. Take care not to
lose these parts.
5. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5YR-F8199-11ch6.pmd 2004/06/11, 14:01 25