Yamaha DPX1000 - Manual (Page 29)

E- 24
Some items are adjusted by increasing or decreasing the value on
the scale, and others by selecting a number or a word.
Press the RESET button to reset the parameter to the factory
setting. (Items without a factory setting cannot be reset.)
5. Press h or g to move the cursor to the next item.
To set a menu item in another menu group, press the ESCAPE
or h button to return to the presently selected menu group, and
follow steps 2—4 described previously to continue with menu
setting.
6.
Press MENU to close the menu when you have
completed any changes.
Menu operation
Operation group A: Press the + or button to open the
submenu. Select the desired parameter using the h or g buttons (h,
g
, +, or – buttons for COLOR TEMP.), then press the ESCAPE
button to close the submenu.
*“SIGNAL STATUS” is a display-only massege which does not
alter any parameters.
Operation group B: Press the + or button to open the
submenu. Select the desired parameter using the h or g buttons,
and press the
button to confirm your setting. Press the
ESCAPE button to close the submenu.
Operation group C: Press the + or button to open the
submenu. Select the desired parameter using the h or g buttons
and then use the + or – buttons to change the parameters. It is not
necessary to confirm the new setting.
Operation group D: Press the + or button to open the
submenu. This submenu is in the form of messages. Follow the on-
screen directions to adjust settings. The submenu for this group is
explained on pages 26 and 27.
—EXCEPTION—
Some submenu items have further submenus attached to them.
These items have “ ” displayed on the right. Press the
button to
enter the detail menu, and select an appropriate setting using the
cursor keys.
Remote control
or
Control panel
MENU MENU
Remote control
or
Control panel
■ Submenus
Following is a list of the menu items that have a submenu.
Submenu operation varies according to the menu item selected.
Follow the steps of the applicable submenu operation group.
Menu items with a submenu
Submenu operation
group
A
C
C
A
A*
B
B
B
B
B
B
A
D
D
A
B
B
A
A
A
Menu group
IMAGE
SIGNAL
INITIAL
SETUP
Menu item
COLOR TEMP.
COLOR BALANCE
LEVEL ADJUSTMENT
DISPLAY ASPECT
SIGNAL STATUS
COLOR SYSTEM
INPUT A SIGNAL
INPUT A SYNC TYPE
INPUT B SIGNAL
INPUT B SYNC TYPE
DVI SIGNAL
DISPLAY LANGUAGE
LAMP RUNNING TIME
RESET
LOCATION
REMOTE CONTROL
SENSOR
REMOTE CONTROL ID
MENU COLOR
TRIGGER OUT
BAUD RATE
Gamma Trim A B C D E
Black Level