Zoom Dialer 27 - Manual (Page 9)

Setting Up the Dialer 5
Hotline Security
Hotline security lets you add a password that is then required for
programming the dialer, and also lets you enable universal call blocking.
Password protection is designed to make it impossible to reprogram your
dialer without first entering the password. Universal call blocking is designed
to make it impossible for a user to dial around the hotline number before the
trigger happens.
Setting a Password
To set up a password, do the following:
1. Take your phone off-hook
2. Press # * 1
3. Enter a password of from 1 to 6 digits, using one of the numbers 0
through 9 for each digit
4. Press # #
5. Listen for two confirmation beeps
6. Place your phone on-hook
Entering a password enables password protection for the dialer. Now you
must enter the password before any dialer programming, so please don't lose
your password. (You may want to write it on the dialer's label.)
Follow this sequence to program the dialer when the password is active.
1. Take your phone off-hook
2. Press #
3. Enter the password
4. Enter the command you want, exactly as it appears in this manual. For
instance, enter #83## to specify triggering upon dialtone detection. (Do
not go on-hook between entering the password and the command.)
5. Listen for two confirmation beeps
6. Place your phone on-hook
You must enter the password before each command you enter.
To disable a password, do the following.
1. Take your phone off-hook
2. Press #
3. Enter the password
4. Press # * 1
5. Press # #
6. Listen for two confirmation beeps
7. Place your phone on-hook