Zoom Dialer 27 - Manual (Page 11)

Setting Up the Dialer 7
(You can keep adding Instructions or Numbers until you reach a limit
that's discussed below, after the examples.)
4. Press # #
5. Listen for two confirmation beeps
6. Place your phone on-hook
List of Instructions for Dialer Strings:
* 1 PPP Pause PP.P seconds (0.1 second increments, 00.1 to
99.9 seconds)
* 2 Listen for Dialtone or computer tone (the tone must
last at least 2.4 seconds)
* 4 Listen for Voice (at least .2 seconds of voice)
* 5 Listen for any DTMF tone
Entering a Number in a Dialer String:
Enter the complete number you want the dialer to dial.
To enter the characters * or #, you need to use the Special Sequence * 0
before the * or #.
The Special Sequence must come at the start of a number. This means
that if * or # occurs in the middle or at the end of a number, you must
break the number into segments. See examples below.
* 0 n Special Sequence for numbers starting with * or # (n = * or #).
Examples:
Suppose you want to program your dialer to call a server, wait for a computer
tone, and then deliver an identifying string. Suppose the server's phone
number is 1 888 555-3333, and the ID string is 0123456789. You could
program the dialer to do this as follows:
1. Take your phone off-hook
2. Enter # 0 # 1 8 8 8 5 5 5 3 3 3 3 # #
3. Listen for two confirmation beeps
4. Place your phone on-hook
5. Take your phone off-hook
6. Enter # 1 # * 2 # #
7. Listen for two confirmation beeps
8. Place your phone on-hook
9. Take your phone off-hook
10. Enter # 1 # 0 1 2 3 4 5 6 7 8 9 # #
11. Listen for two confirmation beeps
12. Place your phone on-hook